This Page is designed to be used with the below video.- N7500/7600, UV 50 Pro, UV Pro, VR-N76 for data modes on Linux and Windows

Save (Ctrl+O, Enter) and Exit (Ctrl+X).

Pairing

**** THIS IS WHERE I HIT A SNAG. DO THE BELOW IF AFTER RUNNING THOSE THREE COMMANDS NOTHING HAPPENS OR YOU GET THE ERROR: SetDiscoveryFilter failed: org.bluez.Error.NotReady

TYPE EXIT TO LEAVE

EDIT:

[Policy] section
CHANGE TO:

[Policy]
AutoEnable=true

Should start scrolling at this point. look for your device (UV-Pro, VR-N7500, etc.) It will have an address like 38:D2:00:01:03:49. Write down your specific address, you will need it again.

Reboot Pi.

Your Raspberry Pi now has a permanent virtual port at /dev/rfcomm0

use /dev/rfcomm0 as the port in Direwolf or other apps.